**This is an old revision of the document!**
#### Saw Blade Cleaning
Supplies:
– CMT Formula 2050 - pump spray
– Bostic Glidekote - can spray
– soft scrubbing sponge, 3M Green Scotch-Brite pad
– soft clean drying cloth
Clean the blade
- Spray on the CMT, let soak a bit,
- scrub blade with something not to harsh so as to damage the finish, sponge or 3M pad
- wipe off dry with clean cloth.
- repeat if needed.
- wipe off well and then spray on the Bostic GlideKote
- let dry a few seconds and wipe off GlideKote
Dust Collection
It's very important to connect the 4“ dust collection hose to the table saw when using. Using the collector and keeping the saws internal hose clear greatly reduces the amount of saw dust that escapes. When cutting you should not see much dust at the back side of the blade. If you do and the Bauer vacuum is running, check to make sure the internal hose is not clogged.
NOTE: It's important to start the big red Bauer dust collector before starting the table saw, due to power draw. The table saw can plug into the same extension cord as the Bauer unit.
The dust port with the 4” quick connect
