Differences

This shows you the differences between two versions of the page.

--- laser_material_library [2025/06/01 18:24] – [Laser Material Library] 8c244b37-0747-c193-0a4e-0967254778dd
+++ laser_material_library [2025/06/21 22:28] (current) – add local setting table 8c244b37-0747-c193-0a4e-0967254778dd
@@ Line 2: / Line 2: @@
 A place to document known-good powers/speeds for various materials.
+### Lightburn Materials Library
+The project design/driving software used in TheLab for driving some but not all laser machines is Lightburn. The Lightburn installs within TheLab have recently been loaded with a Materials Library provided by a member. The settings found within the libraries should be considered starting values rather than values that will give the best results.
-* A document detailing starting power/speed settings for a typical 100 watt Co2 laser courtesy of Thunder Laser USA. It is intended to just be a starting point for speed/power settings. As usual it's best to start testing at the lower power settings.
+Details for accessing/using the materials settings can be found within the Lightburn documentation at:
- * https://support.thunderlaserusa.com/
- * {{laser:Thunder_100_Watt_power-speed.pdf|Suggested Speed/Power Starting Point, PDF}}
+* [[https://docs.lightburnsoftware.com/latest/Reference/MaterialLibrary/|Lightburn Materials Library]]
-## Local Setting
+----
-The following settings are those found to be useful for the local Trogdor machine:
-## Plywood
+### Glowforge Materials settings
-### 3mm
+The Glowforge laser machine is driven by a cloud based product, not Lightburn. Thus the settings are not loaded into Lightburn unless provided by a local user.
-- Cutting on Trogdor: TODO mm/min, TODO % power
+The following settings link can be used as starting values for the Glowforge laser. Values may need to be adjusted based on the wattage of the local machine vs that used to create the library of settings.
-### 5mm
+These setting are courtesy of Smokey Hills Design, a laser supplies company.
-- Cutting on Trogdor: TODO mm/min, TODO % power
+The Company [[https://smokeyhilldesigns.com/| Smokey Hills Designs]]
+The settings [[https://smokeyhilldesigns.com/pages/cut-settings|Glowforge Material Settings]]
-## Acrylic
+----
-### 3mm
+## Custom/Local Setting
+The following settings are those found to be useful by the local members on the local machines. Members are encouraged to add to this list or create a separate file, especially for those items not included in an existing material setting list/library:
-- Cutting on Trogdor: TODO mm/min, TODO % power
+----
-### 5mm
-- Cutting on Trogdor: TODO mm/min, TODO % power
+### Trogdor CO2 laser settings
+Possible Examples only, these have not been verified:
+^            Engraving                                  ^^^^
+^ Material     ^ Speed (mm/sec) ^ Min Power % ^ Max Power % ^
+| Cardboard    |   250         |   5%        | 10%         |
+| Plywood 1/4" |   250         |   10%       | 15%         |
+^            Cutting                                    ^^^^
+^ Material     ^ Speed (mm/sec) ^ Min Power % ^ Max Power % ^
+| Cardboard    |   80          |   15%       | 20%         |
+| Plywood 1/4" |   10          |   60%       | 65%         |
+----
+### Glowforge 40 watt laser settings
+#### Plywood
+#### 3mm
+-  TODO mm/min, TODO % power
+#### 5mm
+-  TODO mm/min, TODO % power