Differences

This shows you the differences between two versions of the page.

--- checklist:shapeokoinitnotes [2025/09/16 19:59] – 8c244b37-0747-c193-0a4e-0967254778dd
+++ checklist:shapeokoinitnotes [2025/11/13 18:32] (current) – 8c244b37-0747-c193-0a4e-0967254778dd
@@ Line 1: / Line 1: @@
 Notes for Initializing the Shapeoko when first starting for the day
-====== **VERY MUCH A WORK IN PROGRESS USE FOR REFERENCE ONLY** ======
+**This detailed guide is subject to change so, for personal and machine safety, please ask an experienced lab member to assist in helping you through your first couple of uses.**
 ## Initializing The Shapeoko Within Carbide Motion ##
   - 1. start Carbine Motion
@@ Line 106: / Line 108: @@
   - Click the "Save ToolPath" button
   - Select one the the ToolPaths listed at the far bottom, Click "Save ToolPath(s)".
+  - Within the "Machine" drop down select "Shapeoko Pro XXL Carbide Motion"
+  - Within the "Post Processor" drop down select "Carbide Motion ATC (mm) (*.nc)" if available. NOTE: This post-processor will support on the fly manual tool changes.
+  - If you do not find within the Machine drop down "Shapeoko Pro XXL Carbide Motion", you can select the "Add post-processor item within the "Post Processor" drop down.
+  - From within "Machine Configuration Management you may be able to select "Shapeoko Pro XXL Carbide Motion" and subsequently "Carbide Motion ATC" within the Associated Post-Processors" list if they have been configured within Carbide Motion.
+  - Click Apply and Ok to save the selection.
   - Select a place to save the ToolPath G-Code where Carbide Motion can get to it.
   - NOTE: Only a full licensed version of VCarve is able to generate/save the required G-Code. The Makerspace home edition will not.