Differences

This shows you the differences between two versions of the page.

--- checklist:shapeokoinitnotes [2025/09/15 18:04] – minor 8c244b37-0747-c193-0a4e-0967254778dd
+++ checklist:shapeokoinitnotes [2025/09/16 19:59] (current) – 8c244b37-0747-c193-0a4e-0967254778dd
@@ Line 1: / Line 1: @@
 Notes for Initializing the Shapeoko when first starting for the day
 ====== **VERY MUCH A WORK IN PROGRESS USE FOR REFERENCE ONLY** ======
+## Initializing The Shapeoko Within Carbide Motion ##
   - 1. start Carbine Motion
   - 2. turn on Shapeoko
@@ Line 107: / Line 107: @@
   - Select one the the ToolPaths listed at the far bottom, Click "Save ToolPath(s)".
   - Select a place to save the ToolPath G-Code where Carbide Motion can get to it.
+  - NOTE: Only a full licensed version of VCarve is able to generate/save the required G-Code. The Makerspace home edition will not.
   - Exit VCarve
 #### Carbide Motion - Run Your Job ####
-  - Start Carbide Motion
+  - Make sure you have successfully run through [[#Initializing The Shapeoko Within Carbide Motion |Initializing The Shapeoko Within Carbide Motion section above]]
-  - Turn on the Shapeoko via the machines round button. ( Note the LED within the button does not function)
-  - At the main page run though the "Initialize" procedure detailed above
   - When Initialization is complete, load your projects G-Code file that was saved from VCarve Pro
-The following  running a job needs expansion/verification
+**The following  running a job needs expansion/verification**
+  - Load your project's generated G-Code file
   - Select the Carbide Motion "RUN" tab
   - Click "Start Job"