Differences

This shows you the differences between two versions of the page.

--- checklist:fdm [2025/03/08 04:35] – ef2d127d-e37b-942b-aad0-6145e54b0c61
+++ checklist:fdm [2026/02/08 22:52] (current) – removed ef2d127d-e37b-942b-aad0-6145e54b0c61
@@ Line 1: / Line 1: @@
-# Bambu 3D Printing Instructions
-## Cost
-If you use filament provided by TheLab, we ask for a donation of $0.03/gram to cover the costs of the materials.
-[[https://www.paypal.com/donate/?hosted_button_id=XHQRUTFXRSWQY|Donate on PayPal]]
-You can find this filament in one of the obviously marked bins under the printers and in the AMS(s).
-## AMS (Automatic Material System)
-Typically there are a few spools of TheLab-owned PLA stocked in the AMSs and labeled appropriately. Use the AMSs for active prints if you like, but the side spool is typically easier if you're only using a single filament per print. Just don't leave your filament in the AMS once your print is done.
-## Personal Filament Storage
-There are three bins under the 3d printers that can be used for short term storage: less than 6 months. Mark your spools with your Discord handle and the date.
-If there isn't room for your spool, throw out (or take home!) the first spool you find that's unmarked or older than six months (prefer empty spools, etc.)
-## Attending Prints
-The Bambus are very reliable/safe printers - just stick around to make sure the first layer sticks before letting the print run unattended.
-## Etiquette
-- If someone else's print has finished, feel free to remove their print and place it in the bin
-- Don't hold up both printers at once unless you've gotten consensus in the `#filament-general` Discord channel first
-- Long prints are okay! Try to run them overnight, leave a note in Discord first.
-- Only use gluestick on plates that require it
-- Vacuum up the inside of the printer enclosure if your print left dust, etc.
-## Sending Prints
-TODO