# Laser Material Library

A place to document known-good powers/speeds for various materials.

* A document detailing starting power/speed settings for a typical 100 watt Co2 laser courtesy of Thunder Laser USA. It is intended to just be a starting point for speed/power settings. As usual it's best to start testing at the lower power settings.
 * https://support.thunderlaserusa.com/

 * {{laser:Thunder_100_Watt_power-speed.pdf|Suggested Speed/Power Starting Point, PDF}}

## Local Setting
The following settings are those found to be useful for the local Trogdor machine:

## Plywood

### 3mm

- Cutting on Trogdor: TODO mm/min, TODO % power

### 5mm

- Cutting on Trogdor: TODO mm/min, TODO % power


## Acrylic

### 3mm

- Cutting on Trogdor: TODO mm/min, TODO % power

### 5mm

- Cutting on Trogdor: TODO mm/min, TODO % power